・When the thread lead angle is 2.2° 　1. In the case when the thread helix angle is 60° (2.2° lead angle) ─ (2.5─0.5°) = -0.3°─1.7° shim inclination angle is appropriate. Threading with a standard shim (0° inclination angle) is possible. But, replacing with a shim with a 1° inclination angle is recommended.

Analytical cookies collect information about your use of this website in an anonymous and aggregated form. These cookies are used to analyze and improve the functionality of this website.

Image

Image

(Note) When a thread lead angle < the tool flank angle, change the shim to prevent side interference with the insert. (Refer to the table below for the calculation of thread lead angle and tool flank angle.)

2. In the case when the thread helix angle is 30° (2.2° lead angle) ─ (2─1°) = -0.2°─1.2° shim inclination angle is appropriate. Replacing with a shim with a 1° inclination angle is recommended.

Image

(Note) When a thread lead angle < the tool flank angle, change the shim to prevent side interference with the insert. (Refer to the table below for the calculation of thread lead angle and tool flank angle.)

These cookies enable this website to provide enhanced functionality and personalisation. They may be set by us or by third party providers. Functional cookies are used by social networking services to track the use of their built-in features. For example, these cookies allow you to share pages from this website with your social network. Advertising cookies may be set through this website by our advertising partners based on the data obtained. They identify your unique browser and Internet device and may be used to provide anonymized demographic data, build profiles of your interests, and display advertising relevant to those interests.

JavaScript seems to be disabled in your browser. For the best experience on our site, be sure to turn on Javascript in your browser.

• Relief angles (β2, β1) of an insert become small when the thread helix angle of a trapezoidal, round, or other thread is small.Take care when selecting a shim.

Necessary  cookies are used to help this website function properly. For example, they provide login retention functionality.

Lead angle (α) depends on a combination of thread diameter and pitch. Select a shim so that the lead angle of the thread can coincide with the flank angles of the thread and insert (β1、β2). No need to change a shim for general threading with an MMT holder. When threading with a small diameter or large pitch, change the shim depending on the lead angle, referring to the table and graph below. When threading left hand threads, change to a shim with a negative inclination angle.